With all checkboxes checked on, click Purge All.
"N" when asked to verify each name to be purged, then Enter. "R" for Regapps (registered applications), then Enter. Purge Registered Applications (from the command line):. Perform the following steps in the order listed: Go to your backup system and restore the file from a time before it became corrupted. If you can open it there, convert the drawing to an older DWG version and try opening again. Try opening the drawing using DWG Trueview. If any exist with a similar name to the corrupted DWG file, then rename the extension to DWG and see if it can then be opened. Look in C:\Windows\Temp for files with an SV$ extension. If so, rename the BAK extension to DWG and see if the file can then be opened. Look in the same directory where the DWG resides and see if there is a BAK file of the same name. Run AUDIT and PURGE commands, and then use SAVEAS to create a new DWG. If it does, then run EXPLODE and select the inserted block. Select the problematic file and see if it will insert. Open a blank DWG and run the INSERT command. AutoCAD will attempt to recover the file and open it. Open a blank DWG and run the RECOVERALL command. Open a blank DWG and run the RECOVER command. If the file opens, there is no need to continue to the rest of the steps. Be sure to stop and try to open the file after each one. If neither of the above options allow you to open the DWG, move on to the next set of steps. 
dwl2 files if they are found alongside your DWG file. You can then go back to the folder directory and delete the.
On the View tab, turn on the option to show hidden files. In the Windows Control Panel, go to Folder Options.
dwl or dwl2 files in the folder directory. These are two hidden files that have the same name as the.
Refer to Error: "Drawing file is not valid" when opening a file in AutoCAD if you receive the "Drawing file is not valid" error when opening the DWG file. Your drawing may show the message "Drawing file is not valid," display a message about errors being found, hang or crash during the open process, or simply may not appear in AutoCAD after you have selected to open it (i.e., you open it but all you ever see is the default "Drawing1.dwg" or another file that you currently have open). If the drawing file (DWG) will not open at all: Solution: Use the following guidelines and instructions to clean, repair, and recover your drawing.
0 kommentar(er)
